[Vini-dev] Error message during "make topo"

[Andy Bavier]

Hi,

>From the error messages you report, it sounds to me like the slice
attributes may not be configured correctly.  Please check:

* The "capabilities" attribute of the slice is set to CAP_NET_ADMIN
* The "netns" attribute of the slice is set to 1 (you need to create
this attribute in MyPLC, it's not there by default)

Let me know if the slice attributes are set as above and the problem persists.

Cheers,
Andy

On Tue, Apr 14, 2009 at 9:27 AM, HyunRyong Lee
<hrlee at netmedia.gist.ac.kr> wrote:
> Hi all,
>
>
>
> In addition to previous my e-mail, I just want to write more about error
> messages.
>
>
>
> Actually, I found that command(“/sbin/ifconfig nat100 10.0.100.2/24 up”) of
> ‘setup-links’ file that is executed during make topo step generates the
> error messages.
>
> After executing ‘setup-link’ file, through ‘/sbin/ifconfig –a’, I could find
> ‘nat100’ interface like below;
>
>
>
> nat100  Link encap:Ethernet HWaddr D6:56:7E:DD:24:CC
>
>            BROADCADT MULTICAST MTU:1500 Metric:1
>
>            Rx packets:0 error:0 dropped:0 overruns:0 frme:0
>
>            Tx packets:0 error:0 dropped:0 overruns:0 carrier:0
>
>            collisions:0 txqueuelen:0
>
>            Rx bytes:0 (0.0 b) Tx bytes:0 (0.0 b)
>
>
>
> I can not understand that how sudoers can get ‘permission denied’ message.
>
>
>
> Could somebody explain this?
>
>
>
> Thanks in advance.
>
>
>
> Sincerely yours,
>
> HyunYong.
>
>
>
> _______________________________________________
> Vini-dev mailing list
> Vini-dev at lists.planet-lab.org
> https://lists.planet-lab.org/mailman/listinfo/vini-dev
>
>